Sign in to follow this  
Followers 0
qizhenapp

installation process

1 post in this topic

 

bending process, the first bend line, and then take polyurethane material, generally about 8MM. Bend as flat as possible. 45 degrees stitching convex plate: After 45 degrees cutting plate, burr flat, re-splicing. Stitching attention tidy as shown in Figure: Umbilicals right angle splicing: splicing plate inside the polished 45 degree angle for

spell, the splicing plate directly into the other plate within the notch. Pay attention to angle control when polishing. Concave plate angle splicing: splicing plate outside the polished 45-degree angle for spell, the splice plate directly into the other plate within the notch. Pay attention to polished angle control, the principle with right angle splicing.

6, the acceptance criteria: the flat material seams neat; close at the Department does not affect the appearance of aesthetics; materials fixed firmly, the wall at the Department of material is not empty phenomenon; color with a reasonable; internal insulation without leakage phenomenon; wave plate butt integrity without burr; Is it at

" covering ugly stoop in Finland , garden paths and walkway floor " " ceiling for outdoor porches in cape town , waterproof porch ceiling "

0

Share this post


Link to post
Share on other sites

Please sign in to comment

You will be able to leave a comment after signing in



Sign In Now
Sign in to follow this  
Followers 0